Each module (e.g. Aeromedical, TCCC) needs to be calibrated so that the manikin is correctly positioned within the scene. Note this needs to be done for both modules, so when you have calibrated the Aeromedical module, make sure you save it, then use mission control to start again and do the same with the TCCC module.
Usually this can be done on the Headset PC in the BlueRoom environment. A panel on the left hand side of the screen will allow you to move the environment’s position relative to the manikin.
If for some reason you cannot see this then the following commands can be used to move the environment around.
Note, depending on your keyboard you may need to hold the function button first, then control. Try to only use the keypad on the RHS.
| Command | Action |
| CTRL SHIFT ALT S | Enables shortcuts (or disables) |
| CTRL & ARROWS | Move environment laterally |
| CTRL & PAGE UP/PAGE DOWN | Move environment vertically |
| CTRL & +/- (on keypad) | Rotate environment |
| CTRL & END | Save changes (don’t forget!) |
| SHIFT | Holding the shift key in addition to the above combinations will amplify changes by 10 |
| M | Toggles debug messages |